- At the same time, the low-pressure primary is sealed in epoxy resin to prevent sparking and flashing, and it looks more beautiful
- Technical Essential: (1) ZVS+ high voltage package booster circuit, simple and reliable, easy to repair or replace
- (2) 8 high-voltage resonant capacitors accurately match the coil parameters to maximize the arc
- (3) The original design of rotating spark gap greatly extends the service life of the product and is full of sense of science and technology
- (4) Original design of separating primary and secondary coils, beautiful in appearance, preventing sparking and safe to use
- (5) Low-pressure primary epoxy glue seal to extend life
- (6) Dual power supply design, adjustable motor speed and frequency
- Usage: (1) Take out the ground wire first, connect the screw near the primary coil on the base of the product to one end of the ground wire, and then connect the other end of the ground wire to a good conductor in contact with the earth
- (2) Connect the adjustable power supply to the socket, adjust the voltage to no more than 7V, and then connect the plug to the motor
- (3) Finally, connect the red and black wires with the switch to the positive and negative terminals on the white power supply, the red wire to the positive pole, and the black wire to the negative pole
- Ensure that there are no debris
- (5) Finally, press the switch to produce an arc, and the louder sound is normal
- Note
- (1) The arc frequency of the product is high, and there will be a burning sensation when touched
- Please do not touch the arc at will
- (2) The discharge needle is relatively sharp, so use it safely
- (3) After power-on, it is not recommended to touch the components on the circuit board except the switch
- (4) If the heat sink is hot, please cut off the power and put it for a while
- (5) The line between the two coils must be suspended in the air and cannot touch the desktop
- (6) Please click the switch, do not press the switch for a long time
- Applications Widely: Suitable as a gift for technology enthusiasts, can be used for Tesla coil teaching demonstrations, can also be used as a technology toy, magical, fun, highly ornamental, inspire enthusiasm for learning and interest in scientific exploration, cultivate innovation ability and creativity
- For Ages: 14+Specifications:
- Color: As Shown
- Material: Metal + Acrylic + Electronic Components
- Coil: 140 x 130 x 340mm
- Base: 240 x 140 x 160mm
- Voltage: 220V to 24V power supply +220V to 0-12V adjustable power supply (dual power supply design)
- Power: Comprehensive power about 100W
- Product Weight: 2450g
- Package Dimensions: 30 x 30 x 40cm
- Package Weight: 3000g
- Packing: BoxPackage Content:
- 1 x High Pressure Secondary with Equalizing Ring
- 1 x Spark Gap Host Base
- 1 x 0-12V Adjustable Motor Power Supply
- 1 x 24V 10A Power Supply